To Next Page

To Previous Page

Channel Combination Commands

Chapter7 Channel Combination Commands

INSTrument[:SELect]

This command is used to switch the channel.

Command syntax

INSTrument[:SELect] {<NR1>}

Arguments

CH1|CH2|CH3

Query syntax

INSTrument[:SELect]?

Note: When the channel is switched by executing the command, the

channel indicator displayed on the VFD does not change.

INSTrument:NSELect

This command is used to switch the channel. The function is the same as

INSTrument[:SELect], but the parameters are different.

Command syntax

INSTrument:NSELect {<NR1>}

Arguments

1-3

Query syntax

INSTrument:NSELect?

INSTrument:COMbine:SERies

This command is used to set the specified channels to serial state. Each

channel is separated by a comma.

Command syntax

INSTrument:COMbine:SERies {<NR2>}

Parameter 1

CH1|CH2|CH3

Parameter 2

CH1|CH2|CH3

Optional Parameter 3

CH1|CH2|CH3

ITech IT6322A Programming Guide

Other manuals for ITech IT6322A