To Next Page

To Previous Page

Function and Features

 Resistor Mode

OFF

Ext-Ctrl Setup

5v-M 5v/5k-P R-P off

Pin 20 and Pin 13 (GND wire) can be connected to a resistor for setting the output voltage

value of the power supply.

To set the 10V/10KΩ or 5V/5KΩ external analog setting range, open the MENU (Menu)

→ CONFIG (Configure) → Ext-Ctrl (External Analog Control).

OFF

Ext-Ctrl Setup

5v-M 5v/5k-P R-P off

Press the Right Key to select 5v/5k-P (or 10v/10k-P). Press the Up/Down Key to select

within the full scale scope under 10V/10KΩ or 5V/5KΩ program.

Current Setting (Current Program)

This function enables change of current output through external analog signal by

connecting external DC voltage (under voltage mode) or an external resistor (under

resistor mode) to Pin 22. To enable this function, the output control should be under the

external analog control mode. Used for controlling the external voltage range of full-scale

output voltage or the resistor can be selected from 0~10V/0~10KΩ or 0~5V/0~5KΩ. To

switch on the current setting, open the MENU (Menu) → CONFIG (Configure) →

Ext-Ctrl (External Analog Control). Press the Right Key to select V-P (or R-P). Press the

Up/Down Key to select the voltage mode or resistor mode.

 Voltage Mode

OFF

Ext-Ctrl Setup

5v-M 5v/5k-P V-P off

Under the voltage mode, the user can set the voltage output value of the power supply

through Pin 22.

ITech IT6512 User Manual

Other manuals for ITech IT6512