To Next Page

To Previous Page

Function and Features

 Resistor Mode

OFF

Ext-Ctrl Setup

5v-M 5v/5k-P R-P off

Pin 22 and Pin 13 (GND wire) can be connected to a resistor for setting the output voltage

value of the power supply.

To set the 10V/10KΩ or 5V/5KΩ external analog setting range, open the MENU (Menu)

→ CONFIG (Configure) → Ext-Ctrl (External Analog Control).

OFF

Ext-Ctrl Setup

5v-M 5v/5k-P R-P off

Press the Right Key to select 5v/5k-P (or 10v/10k-P). Press the Up/Down Key to select

within the full scale scope under 10V/10KΩ or 5V/5KΩ program.

Voltage monitoring

This function enables monitoring of voltage output via Pin 23 or the GND pin (i.e., Pin 13),

which can be connected to a digital voltmeter (DVM). To use this function, the output

control should be under the external analog control mode. The output voltage monitoring

range (which reflects the power supply output voltage from zero to full scale) can be

selected from 0-10V or 0-5V. To switch on the monitoring range setting, open the MENU

(Menu) → CONFIG (Configure) → Ext-Ctrl (External Analog Control). Press the Right

Key to select 10v-M (or 10v-M). Press the Up/Down Key to select the output voltage

monitoring range (0~10V or 0~5V).

OFF

Ext-Ctrl Setup

5v-M 5v/5k-P R-P off

The connection setting of digital voltmeter is shown below.

Current monitoring

This function enables monitoring of current output via Pin 24 or the GND pin (i.e., Pin 13),

which can be connected to a digital voltmeter (DVM). To use this function, the output

control should be under the external analog control mode. The output current monitoring

range (which reflects the power supply output current from zero to full scale) can be

ITech IT6512 User Manual

Other manuals for ITech IT6512