J-100
10.5 Air Controls (except J115/J125)
Certain jet systems have their own air control (if equipped).
Each control introduces air into the water lines that supply
that specic jet group. Simply turn the air control of choice
counterclockwise to open or clockwise to close.
Note: To minimize heat loss, all air controls should be closed when the
spa is not in use. Certain jets may not draw air when jets pump 1 is
running in low speed; this is considered normal.
10.6 Blow-Out Cycle
This cycle will purge the air from the plumbing lines normally caused by
draining and lling the spa. The Jets Pump 1 (low speed) will turn on for
1 minute and then shut off. Then Jets Pump 2 (if equipped) will turn on
and run for 1 minute then shut off. This cycle will only occur at start up.
Note: Turning off the corresponding jets pump that is running can
deactivate the feature.
10.7 Cleanup Cycle
The cleanup cycle occurs once per day at 12:00 PM (noon) for 2
minutes. This is not user programmable. The Jets Pump 1 (low speed)
will turn on for one minute and then shut off. Then Jets Pump 2 (if
equipped) will turn on and run for 1 minute then shut off.
Note: Turning off the corresponding jets pump that is running can
deactivate the feature.
28
To Next Page
Loading...
Need help?
General
