Jacuzzi J-135 User Manual

J-100
4. Press
1
to conrm and save the start time.
5. Press or to adjust the number of cycles per day, either 1, 2,
3, 4 or 8 cycles in a 24-hour period.
6. Press
1
to conrm and save the changes.
7. Press or to adjust the duration of the cycles, either 1, 2, or 3
hour cycles.
8. Press
1
to conrm and save the duration time. The system will
return to the “PRIMARY FILTER” Menu.
In extreme bitter cold weather, where freezing can occur, we
recommend you program the primary ltration cycle to run
for a minimum of 8 hours per day. Refer to the “Winterizing”
section on page 39.
11.2 Programming the Heating Mode
Your hot tub is equipped with 3 modes of heating. An automatic mode
called “AUTO,” where the hot tub’s temperature is maintained at all
times. An energy saving heating cycle called “ECO.” Lastly, a mode that
will only activate the heater during the daytime called “DAY” mode.
• Economy Mode is an energy savings program. The hot tub is allowed
to heat between 5:00 PM and 7:00 AM every day. The hours are not
programmable.
• Day Mode allows the hot tub to heat during the day, between 7:00
AM to 5:00 PM. The hours are not programmable.
• Auto Mode allows the heater to heat, at all times, in order to maintain
the preset temperature.
Note: The heater will reactivate after the water cools to
approximately 2°F (1°C) below the set temperature.
A. Programming the Heating Mode
To change the programmed heating mode:
Note: If no button is pressed within 5 seconds of each selection the
screen will revert back to the Main Menu and the current settings will
remain active.
1. Press
until you get to the “HEAT” Menu. The display will scroll
“HEATER MODE.” After the second scroll, if no action is taken, the
system will revert back to the Main Menu.
2. Press or to prepare the system for changes. Continually
press to scroll through the following modes:
• Economy Mode: The screen will display “ECO” and scroll
“ECONOMY MODE.”
• Day Mode: The screen will display “DAY” and scroll “DAY MODE.”
• Auto Mode: The screen will display “AUTO” and scroll “AUTO
MODE.”
3. Once a selection is made, press
1
to conrm and activate the
setting. The system will return to the “HEATER MODE” Menu.
30

Jacuzzi J-135 Specifications

General

Brand	Jacuzzi
Model	J-135
Category	Hot Tub
Language	English