Maintenance
Operator Station
132 9821/6100-4 132
Operator Station
General
Clean
Notice: Never use water or steam to clean inside the operator station. The use of water or steam could
damage the machine electrics and render the machine inoperable. Remove dirt using a brush or damp cloth.
Remove debris and loose articles from inside the cab.
Operator Protective Structure
Check (Condition)
WARNING You could be killed or seriously injured if you operate a machine with a damaged or missing
ROPS/FOPS/FOGS. If the ROPS/FOPS/FOGS has been in an accident, do not use the machine until the
structure has been renewed. Modifications and repairs that are not approved by the manufacturer may be
dangerous and will invalidate the ROPS/FOPS/FOGS certification.
A failure to adhere to these precautions can cause death or injury to the operator. For assistance, contact your
JCB dealer.
1. Make the machine safe.
Refer to: Maintenance Positions (Page 122).
2. Check the structure for damage.
3. Make sure that all of the ROPS/FOPS mounting bolts are undamaged and in position.
4. Make sure that the ROPS/FOPS mounting bolts are tightened to the correct torque setting.
Refer to: Torque Values (Page 181).
Seat
Check (Condition)
1. Check that the seat adjustments operate correctly.
2. Check the seat is undamaged.
3. Check the seat mounting bolts are undamaged, correctly installed and tight.
4. Make sure the seat is clear from unwanted materials and hazards at all times.
Seat Belt
Check (Condition)
WARNING When a seat belt is installed on your machine replace it with a new one if it is damaged, if the
fabric is worn, or if the machine has been in an accident.
WARNING If the seat belt does not 'lock' when you check if the seat belt is operating correctly, do not drive
the machine. Get the seat belt repaired or replaced immediately.
1. Make sure the seat belt can be adjusted.
2. Examine the seat belt for signs of fraying and stretching.
3. Check that the stitching is not loose or damaged.
To Next Page
Loading...
Need help?
General
