Operation
Entering and Leaving the Operator Station
26 9821/6100-4 26
Entering and Leaving the Operator Station
General
WARNING For safety reasons, machines installed with single access canopies from new must not have
the barrier removed. The machine must always be entered/exited with the left hand isolator raised via the
left hand side.
WARNING Do not enter or exit the cab unless the controls isolation lever is in the fully raised position.
CAUTION Entering or leaving the operator station must only be made where steps and handrails are
provided. Always face the machine when entering and leaving. Make sure the step(s), handrails and your
boot soles are clean and dry. Do not jump from the machine. Do not use the machine controls as handholds,
use the handrails.
Entering the Cab
1. Open the cab door and if necessary attach it in the open position.
Refer to: Operator Door (Page 30).
2. Check that the left controls console is raised. When the left controls console is in the raised position the
excavator, track, dozer, swing, and auxiliary controls cannot be operated.
Refer to: Control Lock (Page 49).
Figure 12.
A Handle B Left controls console
3. Hold the two handrails (one each side of the cab entrance), use the track to climb to the step.
To Next Page
Loading...
Need help?
General
