Operation
Battery Isolator
32 9831/7750-1 32
Battery Isolator
General
Notice: Before carrying out arc welding on the machine, disconnect the battery and alternator to protect
the circuits and components. The battery must still be disconnected even if a battery isolator is installed.
Notice: Do not isolate the machine electrics when the engine is running, this may cause damage to the
machine electrics.
Disconnect the Machine Electrics:
1. Turn the ignition key to the off position.
2. Get access to the battery isolator.
Refer to: Service Points (Page 88).
3. Turn the battery isolator key in a counter-clockwise direction and remove.
Connect the Machine Electrics:
1. Make sure the ignition is switched off.
2. Insert the battery isolator key and turn in a clockwise direction.
To Next Page
Loading...
Need help?
General
