Routine Maintenance
Checking for Damage
111 111
9811/5700-7
Checking for Damage
Check the Machine Body and Structure
T3-063_5
Make sure that all guards and protective devices are in
place, attached by their locking devices and free from
damage.
Inspect all steelwork for damage. Pay particular attention
to the following:
– Inspect all lifting point welds.
– Inspect all pivot point welds.
– Inspect the condition of all pivot pins.
– Check pivot pins are correctly in place and secured by
their locking devices.
Check steps and handrails are undamaged and secure.
Check for broken, cracked or crazed window glass and
mirrors. Replace damaged items.
Check all lamp lenses for damage.
Check all attachment teeth are undamaged and secure.
Check all safety and instructional labels are in place and
undamaged. Fit new labels where necessary.
Note damaged paintwork for future repair.
Check the Tyres
T3-065_2
!MWARNING
You could be killed or injured if a machine tyre bursts.
Do not use the machine with damaged, incorrectly
inflated or excessively worn tyres. Recognise the
speed limitation of the tyres fitted and do not operate
at more than their recommended maximum speed.
13-2-1-2
Always drive with consideration for the condition of the
tyres. Incorrect tyre pressures will affect the stability of the
machine. Check the tyres daily for the correct tyre
pressure and signs of damage. For example:
– Signs of distortion (bulges)
– Cuts or wear
– Embedded objects (nails, etc.)
Install the valve caps firmly to prevent dirt from entering the
valve. Inspect for leaks when you check the tyre
pressures.
Inspect the tyre valve for leaks, when you check the tyre
pressures.
Check the Seat and Seat Belt
T3-008_2
!MWARNING
When a seat belt is fitted to your machine replace it
with a new one if it is damaged, if the fabric is worn, or
if the machine has been in an accident. Fit a new seat
belt every three years.
2-3-1-7_1
Inspect the seat belt for signs of fraying and stretching.
Check that the stitching is not loose or damaged. Check
that the buckle assembly is undamaged and works
correctly.
Check that the belt mounting bolts are undamaged,
correctly fitted and tightened.
Check seats are undamaged and secure. Check seat
adjustments for correct operation.
Check the Hydraulic Hoses and Fittings
T3-072
!MWARNING
Hydraulic Hoses
Damaged hoses can cause fatal accidents. Inspect the
hoses regularly. Do not use the machine if a hose or
hose fitting is damaged.
INT-3-3-2_4
Inspect the hoses regularly for:
– Damaged hose ends
– Chafed outer covers
– Ballooned outer covers
– Kinked or crushed hoses
– Embedded armouring in outer covers
– Displaced end fittings
To Next Page
Loading...
Need help?
General
