Introduction
Identifying Your Machine
23 23
9811/5700-7
ROPS/FOPS Certification Plate
823860-2
Fig 10.
Machines built to ROPS/FOPS standards have an
identification label A fitted to the inside of the cab.
K
Fig 10. ( T 23).
The FOPS structure provides Impact Protection against
falling objects (as defined in ISO 6005:2004).
FOPS Data Plate
!MWARNING
Do not use the machine if the falling objects protection
level provided by the structure is not sufficient for the
application. Falling objects can cause serious injury.
8-2-8-17
If the machine is used in any application where there is a
risk of falling objects then a falling-objects protective
structure (FOPS) must be installed. For further information
contact your JCB Dealer
The falling objects protection structure (FOPS) is fitted with
a dataplate. The dataplate indicates what level protection
the structure provides.
Note: A load backrest extension can be fitted to minimise
the possibility of the load failing towards the mast when the
mast is in a position of maximum reward tilt. A screen
guard can also be fitted to provide protection from objects
coming from the front, contact your JCB distributor.
Definition of terms:
ROPS Roll Over Protection Structure
FOPS Falling Objects Protection Structure
To Next Page
Loading...
Need help?
General
