Routine Maintenance
Access Panels
121 121
9811/5700-7
Access Panels
Introduction
T3-100
When placed in their maintenance position, the access
panels give you access to parts or areas of the machine
that are not required during machine operation.
Before you operate the machine, make sure that all of the
access panels are in their operation position and secure.
Engine Cover
Opening and Closing
Access to the engine is by opening the cover A.
!MWARNING
The engine has exposed rotating parts. Switch OFF the
engine before working in the engine compartment. Do
not use the machine with the engine cover open.
5-2-6-5
!MWARNING
Touching hot surfaces can burn skin. The engine and
machine components will be hot after the unit has
been running. Allow the engine and components to
cool before servicing the unit.
10-1-1-40
Important: Before you stop the engine, you must allow the
engine to operate at low idle for four minutes. The delay
allows the coolant temperatures to stabilise before you
open the engine cover.
1 Make the machine safe with the mast lowered. Refer
to Prepare the Machine for Maintenance.
2 Release latches B. Allow the cover to raise on it's gas
strut. Keep hold of the handles C while it rises.
Important: Do not leave the cover raised part-way; it can
creep down.
3 Lower the cover A and engage latches B.
Fig 85.
To Next Page
Loading...
Need help?
General
