To Next Page

To Previous Page

Routine Maintenance

Hydraulic System

150 150

9811/5700-7

Changing the Filter Element

!MWARNING

Fluid Under Pressure

Fine jets of fluid at high pressure can penetrate the

skin. Keep face and hands well clear of fluid under

pressure and wear protective glasses and gloves.

Hold a piece of cardboard close to suspected leaks

and then inspect the cardboard for signs of fluid. If

fluid penetrates your skin, get medical help

immediately.

INT-3-1-10_3

1 Make the machine safe with the mast lowered. Refer

to Prepare the Machine for Maintenance.

2 Vent the hydraulic system. Refer to Releasing the

Hydraulic pressure.

3 Place a container of suitable size below the hydraulic

filter to catch the oil.

4 From under the machine, unscrew and remove the

element A. The element will contain hydraulic fluid;

keep your face clear of spilling fluid.

5 Clean the mating faces on the new element and filter

holder.

6 Smear the seal B with hydraulic fluid and screw the

new element in place, hand-tight only.

7 Add recommended hydraulic fluid.

8 Replace the filler cap. Make the machine safe (See

step 1), run the engine and check for leaks at the filter.

Fig 114.

jcb RTFL 926 User Manual

Questions and Answers: