19
Bobbin thread preparation
Open the hook cover.
Take out the bobbin.
* If the bobbin has too little thread, do not use it as the thread will get tangled.
* Use only the designated bobbin. Other bobbins may cause malfunction.
Taking out the bobbin
1
Small spool
Spool Cap
Place a thread spool to spool pin and a spool cap onto the spool pin.
* Do not use the thread cone with a small amount of thread. This may cause thread
tangling and/or the thread coming out of the eye of the needle when starting to sew.
There are three types of the spool caps, large, medium and small. Choose the size of
spool cap according to the thread spool to be used.
Setting thread spool
Attention
When the bobbin is taken out and/or put into the bobbin case, turn off the power (turn to “O”).
1
2
Large spool
Spool Cap
Hook cover
To Next Page
Loading...
Need help?
General
