To Next Page

To Previous Page

JUNOSe 7.2.x Policy Management Configuration Guide

42 ! Creating Classifier Groups and Policy Rules

next-interface

! Use to define an output interface to which the packets conforming to the

current CLACL are forwarded.

! For IP interfaces, this command is supported only on input policies.

! IP interfaces referenced with this command can be tracked if they move.

Policies attached to an interface also move if the interface moves. However,

statistics are not maintained across the move.

! Example

host1(config-policy-list-classifier-group)#next-interface atm 0/0.1

! You can no longer use an interface specifier of tunnel:mpls with the

next-interface command, because that usage requires IP interfaces on top of

RSVP-TE tunnels. Such interfaces are no longer present in the redesigned MPLS

architecture. However, you can configure a static route for an address that is not

otherwise used to point to a tunnel, and then use the forward next-hop

command in the policy:

host1(config)#ip route 10.10.10.10/32 tunnel mpls:foo

host1(config)#ip policy-list bar

host1(config-policy-list-classifier-group)#forward next-hop 10.10.10.10

! Use the suspend version to suspend the next-interface rule within the classifier

group.

! Use the no version to remove the next-interface rule from the classifier group.

rate-limit-profile

! Use to specify a rate-limit rule for packets conforming to the current CLACL. See

Chapter 3, Creating Rate-Limit Profiles for examples of using this command to

rate limit traffic flows.

! Use the hierarchical keyword to create a hierarchical rate limit.

! Example

host1(config-policy-list-classifier-group)#rate-limit-profile tcpFriendly8MB

! Use the suspend version to suspend the rate-limit-profile rule within the

classifier group.

! Use the no version to remove the rate-limit-profile from the classifier group.

NOTE: The forward interface command replaces the next-interface command.

The next-interface command may be removed in a future release. See the

forward interface command for details.

The SRP module Fast Ethernet port cannot be the destination of the

next-interface command.

Juniper E Series Configuration Guide

Other manuals for Juniper E Series