Juniper E Series Configuration Guide

JUNOSe 7.2.x Policy Management Configuration Guide
72 ! Applying Policy Lists to Interfaces and Profiles
Referenced by interface(s):
ATM4/0.0 input policy, statistics enabled, virtual-router default
Referenced by profile(s):
No profile references
IP Policy plout_7
Administrative state: enable
Reference count: 1
Classifier control list: clout_7_04, precedence 100
forward
Classifier control list: clout_7_05, precedence 100
filter
Classifier control list: clout_7_06, precedence 100
forward
Classifier control list: *, precedence 100
filter
Referenced by interface(s):
ATM4/0.0 output policy, statistics enabled, virtual-router default
Referenced by profile(s):
No profile references
Example 4 In this example, the following Ascend-Data-Filter attribute creates a RADIUS record
that configures an input policy. The policy filters TCP packets from host address
10.2.1.2 to any destination. The policy marks the packets with a ToS byte of 5 and a
mask of 170. The policy also applies a traffic class named someTcl and a rate-limit
profile named someRlp.
The values specified in the Ascend-Data-Filter attribute are listed in Ta b l e 8 .
Ascend-Data-Filter="01010100 0a020102 00000000 20000600 045708ae 02010000
05aa0773 6f6d6554 636c0773 6f6d6552 6c70"
Table 8: Ascend-Data-Filter Example 4 Values
Action or Classifier Hex Value Actual Value
Type 01 IP
Forward 01 Filter
Indirection 01 Ingress
Spare 00 None
Source IP address 0a020102 10.2.1.2
Destination IP address 00000000 Any
Source IP mask 20 32 (0.0.0.0)
Destination IP mask 00 0 (255.255.255.255)
Protocol 06 TCP
Established 00 None
Source port 0000 None
Destination port 0000 None
Source port qualifier 00 None
Destination port qualifier 00 None
Reserved 0000 None

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English