Eligible Slots for SRX1400, SRX3400, and SRX3600 Services Gateway Modules
Table 2 on page 4 summarizes the slots in which you can install each module type for
SRX1400, SRX3400, and SRX3600 Services Gateways.
Table 2: Supported Slots for SRX1400, SRX3400, and SRX3600 Services Gateway Modules
Supported Slots
Module Name and Number SRX3600SRX3400SRX1400
Front slots labeled 1-6 and rear
slots labeled 7-12. We
recommend that you install
SPCs in rear panel slots to leave
room for IOCs in the front panel
slots.
See note below for additional
restrictions.
Front slots labeled 1-4 and
rear slots labeled 5-7. We
recommend that you install
SPCs in rear panel slots to
leave room for IOCs in the
front panel slots.
See note below for
additional restrictions.
Front slot labeled 1 (When
installed as primary SPC in
conjunction with an
SRX3K-NPC in slot 3)
Front slot labeled 2 (When
installed as second SPC)
“Services Processing Card
SRX3K-SPC-1-10-40” on
page 6
Rear slots labeled 10-12Rear slots labeled 5-7.Slot 3 (When installed as the
primary NPC in conjunction
with an SRX3K-SPC in slot
1)
“Network Processing Card
SRX3K-NPC” on page 16
Front slots labeled 1-6, except
as noted below.
Front slots labeled 1-4,
except as noted below.
Slot 2“I/O Card SRX3K-16GE-TX”
on page 8
“I/O Card SRX3K-16GE-SFP”
on page 10
“I/O Card SRX3K-2XGE-XFP”
on page 12
Front slots labeled 1-6 and rear
slots labeled 7-12. We
recommend that you install
IOCs in front panel slots to
simplify cable management.
Front slots labeled 1-4 and
rear slots labeled 5-7. We
recommend that you install
IOCs in front panel slots to
simplify cable management.
Slot 2“Network Processing I/O Card
SRX1K3K-NP-2XGE-SFPP” on
page 14
Rear slot labeled RE0. (SRX3K-RE-12-10 only)Front slot labeled RE
(SRX1K-RE-12-10 only)
“Routing Engines
SRX3K-RE-12-10 and
SRX1K-RE-12-10” on page 18
Rear slot labeled RE1.Not Applicable“SRX Clustering Module
SRX3K-CRM” on page 20
Copyright © 2016, Juniper Networks, Inc.4
SRX1400, SRX3400, and SRX3600 Services Gateway Module Guide