When the following messages appear...
Message Description Action
.
0
No device is connected to the input
terminal
0
The input terminal is connected but
there is no signal
Input the video signals.
.
A video signal that cannot be used with
this unit has been input (The names of
input terminals such as “HDMI-1” and
“HDMI-2” will be displayed in yellow).
Input video signals that can be used.
(p. 77
)
.
This message is displayed when the
accumulated lamp time has exceeded
2900 hours.
To
clear
the
message,
press
the [BACK]
button on the operation panel of the
projector unit or the remote control.
Get ready a new lamp unit and replace
as soon as possible. Reset the lamp time
after replacing the lamp. (p. 61, 63)
69
Troubleshooting
To Next Page
Loading...
Need help?
General
