JVC HR-A637E User Manual

EN 17
TIMER RECORDING
Information
On ShowView
With ShowView, timer programming is greatly simplified
because each TV programme has a corresponding code number
which your recorder is able to recognise.
NOTE:
“Guide Prog. Number” refers to the assigned TV station
numbers, according to broadcast area, for ShowView timer
recording.
IMPORTANT
Perform the following procedure after the channel setting steps
on pages 7 and 24 – 25, and after the Clock Set procedure on
page 8.
After setting the Guide Prog. Numbers, the station names and
channel positions may be incorrect if you stored or skipped
channels. In this case, re-perform Guide Prog. Number setting.
Guide Prog. Number Set
MAKE LIST OF STORED
CHANNEL POSITIONS
AND STATION NAMES
1
(Ex.)
ACCESS CH. SET DISPLAY
2
Press and hold CH SET for over 2 seconds. “AUTO”
appears on the front display panel.
ACCESS GUIDE PROG. SET
DISPLAY
3
Press PUSH JOG%
fi
to select “GUID”, then press OK.
The Guide Prog. Set display appears.
Channel position Station name
1 ARD
2 ZDF
3 WDR
Guide Prog.
≠
Channel Position
≠
q
6
12
45
3
6
8
0
7
9
1
3
2
OK
NUMBER
CH SET
CANCEL
PUSH JOG
TV PROG.
CONTINUED ON NEXT PAGE.

JVC HR-A637E Specifications

Power

power requirement	AC 220 – 240 V, 50/60 Hz
power consumption	24 W

Operating Environment

operating temperature	5°C to 40°C
storage temperature	–20°C to 60°C
operating position	Horizontal only

Video/Audio

signal system	PAL-type colour signal and CCIR monochrome signal, 625 lines/50 fields
signal-to-noise ratio	45 dB
horizontal resolution	250 lines

Tuner/Timer

tv channel storage capacity	99 positions
channel coverage	VHF 47 – 89/104 – 300/302 – 470MHz, UHF 470 – 862MHz
aerial output	UHF channel 36 (Adjustable 32 – 40)

Weight and Dimensions

dimensions	400 x 94 x 338 mm
weight	4.3 kg