18
Operation
Adjusting the projected image
Adjusting the projection angle
The projector is equipped with 2 adjuster feet. These
adjusters change the image height and projection angle.
Screw the feet in or out as appropriate to aim and level the
projection angle.
If the screen and the projector are not perpendicular to each
other, the projected image becomes vertical trapezoidal. To
correct this, see "Auto-adjusting the image" for details.
Auto-adjusting the image
In some cases, you may wish to optimize the picture
quality of PC signal. To do this, press AUTO. Within 3
seconds, the built-in Intelligent Auto Adjustment function
will re-adjust the values of Frequency and Clock to provide
the best picture quality.
The current input source information will be displayed in the corner of the screen for 3 seconds.
This function is only available when PC signal is selected.
Fine-tuning the image size and clarity
To adjust the projected picture size, turn the zoom ring on the projector after opening the lens
adjustment panel cover.
To sharpen the picture, rotate the focus ring on the projector after opening the lens adjustment
panel cover.
Do not look into the lens while the
lamp is on. The strong light from
the lamp may cause damage to
your eyes.
Be careful when you press the
quick-release button as it is close
to the exhaust vent where hot air
comes from.
To Next Page
Loading...
Need help?
General
