– 8 –
To remove the speaker grille
The speaker grilles are removable as shown below:
To remove the speaker grille, insert your fingers at the top
of the speaker grille, then pull towards you. Do the same at
the bottom.
To attach the speaker grille, put the projections of the
speaker into the holes of the speaker grille.
Connecting Other Equipment
You can connect the following equipment to this unit:
• Cassette deck—used as a playback and recording device.
By using the cassette deck, you can record any source
played back on this unit.
• Audio equipment with an optical digital output
terminal—used only as a digital playback device.
• PC with a USB port—used only as a digital playback
device (for details, see pages 33 to 36).
When you connect and use these equipment, refer also to
the manuals supplied with them.
• DO NOT connect other equipment while the
power is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect another component such as a cassette
deck
Be sure that the plugs of the audio cords and the jacks on
the rear of the unit are color coded: White plugs and jacks
are for left audio signals, and red ones for right audio
signals.
Projections Holes
Speaker grille
By using audio cords (not supplied), connect:
• Between the audio input jacks on the cassette deck and
the LINE OUT jacks—For recording on the cassette
deck.
• Between the audio output jacks on the cassette deck and
the LINE IN jacks—For playing a tape.
To connect audio equipment with an optical digital
output terminal
Connect between the optical digital output terminal on the
other equipment and the OPTICAL DIGITAL IN terminal.
Continued
To optical digital
output
Protective cap
Before connecting the other equipment,
remove the protective cap from the terminal.
Audio equipment with an
optical digital output
To input (REC)
To output (PLAY)
Ex. Cassette deck
LINE IN
LINE OUT
EN01-09_CA-NXMD1R[B]f.pm6 01.8.20, 11:348
To Next Page
Loading...
Need help?
General
