JVC NX-MD1 User Manual

– 49 –
Adding a Track to a Group—ENTRY GR
This function allows you to enter a track into a group. The
track will be added as the last track in the selected group.
The track numbers will be renumbered.
• To stop any time during the editing process after step
3 ,
press MD TITLE/EDIT.
On the remote control ONLY:
In the following example, the process is explained from the
very first—that is, inserting a disc. You can also edit an MD
during playback (in Normal play mode).
1 Insert an MD you want to edit into the MD loading
slot while the unit is turned on.
• If the GROUP indicator is not lit on the display, press
GROUP to activate this function.
2 Press MD TITLE/EDIT repeatedly until “ENTRY
GR?” appears in the main display.
• If the loaded MD has no groups, “ENTRY GR?” will
not appear.
• If you want to stop this editing process, press
ENTER.
3 Press SET.
• During playback:
The current track number starts flashing.
4 Press ¡/¢ or 4/1 to select the track.
• You can select the track using number buttons. In this
case, the selected track starts playback repeatedly.
Ex. When track 10 is selected
5 Press SET.
• When the selected track belongs to the group, its
group number appears in the main display.
• To cancel the setting, press CANCEL, then repeat
step
4 .
6 Press GROUP or to select the group.
• During playback:
The tracks in the selected group are played back
repeatedly.
7 Press SET.
• To cancel the setting, press CANCEL, then repeat
step
4 .
8 Press ENTER.
“EDITING” appears in the main display for a while,
then “WRITING” flashes while the editing you have
made is being recorded on the MD.
When “CANNOT ENTRY” appears in the main
display
You are trying to enter a track in a group into the same group
again. Repeat procedure from step 6 .
Ex. When group 2 is selected
• During playback:
The selected track starts playback repeatedly.
EN45-59_CA-NXMD1R[B]f.pm6 01.8.20, 11:3449

JVC NX-MD1 Specifications

General

Brand	JVC
Model	NX-MD1
Category	Speaker System
Language	English