JVC NX-MD1 User Manual

– 56 –
Dividing a Track—DIVIDE
This function allows you to divide one track into two
separate tracks. It is useful, for example, when you want to
add track marks at a certain point within a track or if you
want to separate a recording.
When the original track has a title, two separate tracks are
reassigned the same title as the original track.
Once a new track is divided, the other tracks are
renumbered.
• To stop any time during the editing process after step
3 ,
press MD TITLE/EDIT.
On the remote control ONLY:
In the following example, the process is explained from the
very first—that is, inserting a disc. You can also edit an MD
during playback (in Normal play mode).
1 Insert an MD you want to edit into the MD loading
slot while the unit is turned on.
• If the GROUP indicator is lit on the display, press
GROUP to turn off the GROUP indicator.
2 Press MD TITLE/EDIT repeatedly until
“DIVIDE?” appears in the main display.
• If the loaded MD has no or 254 tracks, “DIVIDE?”
will not appear. (See “MD limitations” on page 70.)
• If you want to stop this editing process, press
ENTER.
3 Press SET.
The first track on the MD starts playback repeatedly.
• During playback:
The current track number starts playback repeatedly.
4 Press ¡/¢ or 4/1 to select the track you
want to divide.
• You can select the track using number buttons. In this
case, the selected track starts playback repeatedly.
• During playback:
The selected track starts playback repeatedly.
Ex. When the track 3 is selected
Continued
Ex. When adjusting the point by +20
5 Press SET when you find the point where you want
to divide the track.
“POSIT.(position) 0” appears in the main display, and
the unit repeats the selected point—a 3-second period
following the dividing point.
• If the dividing point is satisfactory, go to step 7 .
If not, go to the next step.
• To cancel the setting, press CANCEL, then repeat
step
4 .
6 Press ¡/¢ or 4/1 to precisely adjust the
dividing point.
When you stop pressing the buttons, the unit repeats the
newly selected dividing point.
• You can shift the dividing point up to ±128. This
range (±128) corresponds to approximately ±8*
seconds (counted on the basis of SP mode) from the
original point (Position 0).
* When “SP” is selected for the recording length
mode. For “LP2,” it is approximately ±16
seconds, and for “LP4” approximately ±32
seconds.
• When you find the right position, go to the next step.
• To cancel the setting, press CANCEL, then repeat
step
4 .
7 Press SET.
8 Press ENTER.
“EDITING” appears in the main display for a while,
then “WRITING” flashes while the editing you have
made is being recorded on the MD.
To join the divided tracks again, see the JOIN function
on page 57.
EN45-59_CA-NXMD1R[B]f.pm6 01.8.20, 11:3556

JVC NX-MD1 Specifications

General

Brand	JVC
Model	NX-MD1
Category	Speaker System
Language	English