– 12 –
Changing the Display Brightness
You can change the display brightness while the unit is
turned on.
On the remote control ONLY:
Press DIMMER (CONTRAST).
The display illumination dims and the volume lamp goes
off.
• Each time you press the button, the display brightness
alternates between normal mode and dimmer mode.
Changing the Display Contrast
You can change the display contrast while the unit is turned
on.
On the remote control ONLY:
1
Press and hold CONTRAST (DIMMER) for more
than 2 seconds.
“CONTRAST” and the current setting appear in the
main display.
2
Press ¡/¢ or 4/1 repeatedly to adjust the
contrast.
• You can adjust the contrast within the range of 0 to
+7.
3
Press ENTER to finish setting.
• If you do not press the button about 60 seconds, the
setting will also be stored, then the source indication
will be resumed.
Setting the Auto Power Off
Auto Power Off function automatically turns off the unit if
no sound comes in for more than 3 minutes except when
FM or AM (MW/LW) is selected as the source.
If any operation is done during this 3-minute period, Auto
Power Off is canceled temporarily even though no sound
comes in.
On the remote control ONLY:
To activate Auto Power Off, press A.P.off.
The A.P.off indicator lights up on the display and “A.P.off
SET” appears in the main display.
• When no sound comes in, the A.P.off indicator starts
flashing on the display. About 20 seconds before the unit
turns itself off, the unit starts counting down the time.
To deactivate Auto Power Off, press A.P.off.
The A.P.off indicator goes off from the display and “A.P.off
CANCEL” appears in the main display.
Continued
A.P.off indicator
EN10-15_CA-NXMD1R[B]f.pm6 01.8.20, 11:3412
To Next Page
Loading...
Need help?
General
