Basic Operations
Front Panel
n_ [.m [_,"L_II_
Press STANDBY/ON ©/I (or STANDBY/ON ©/I AUDIO on the
remote control).
STANDBY/ON
........ OD/I
%
On the front panel From the remote control
The STANDBY lamp goes off. The name of the current source (or
station frequency) appears on the display.
Current source name appears
_"ra
TI I I ll
II II JJ
Current volume level is shown here
To turn off the power (into standby mode)
Press STANDBY/ON 0/I (or
STANDBY/ON Oil AUDIO on the remote
control) again.
The STANDBY lamp on the front panel lights up.
STANDBY/O_/_
Note:
A small amount of power is consumed in standby mode. To turn the
power off completely, unplug the AC power cord.
Press one of the source selecting buttons. The selected source name
appears on the display.
DVD VCR TVSOUND
I/ II II /I
CD TAPFJCDR FM/AM
I[ II II jl
On the front panel
TAPE/CDR CD DVD
FM/AM TV SOUND VCR
From the remote control
DVD
VCR
TV SOUND
CD *
TAPE/CDR *
FM/AM *
Notes:
Select the DVD player.
Select the VCR.
Select the TV sound (or the CATV converter).
Select the CD player.
Select the cassette deck (or the CD recorder).
Select an FM or AM broadcast.
° Each time you press the button, the band
alternates between FM and AM.
• When connecting a CD recorder (to the TAPE/CDRjacks), change
the source name that appears on the display, See below for details.
• When you have connected some digital source components using
the digital terminals (see page 7), you need to select the digital
input mode (see page 11).
• When you press one of the source selecting buttons on the remote
control marked above with an asterisk (*), the receiver
automatically turns on.
Changing the source name
When you connect the CD recorder to the TAPE/
CDR jacks on the rear panel and select the CD
recorder as the source, change the source name
shown on the display.
Press TAPE/CDR (SOURCE NAME).
° Make sure "TAPE" appears on the display.
2 Press and hold SOURCE NAME
(TAPE/CDR) until "ASSIGN CDR" appears on the display.
To change the source name from "CDR" to "TAPE" repeat the
same procedure above (in step I, make sure "CDR" appears on the
display).
Note:
Without changing the source name, you can still use the connected
component. However, there may be some inconvenience.
- "TAPE" will appear on the display when you select the CD
recorder.
- You cannot use the digital input (see page 11) for the CD recorder.
- You cannot use the COMPU LINK remote control system (see page
24) to operate the CD recorder.
8
To Next Page
Loading...
Need help?
General
