Troubleshooting
Use this chart to help you solve daily operational problems. If there is any problems you cannot solve, contact your JVC's service center.
The power does not come on. The power cord is not plugged in. Plug the power cord into an AC outlet.
The SPEAKERS ON/OFF button is not
set correctly.
Press SPEAKERS ON/OFF button correctly.
Muting is activated.
Press MUTINGto cancel themute.
Connections are incorrect. Check connections.
For analog connections, see page 6.
For digital connections, see page 7.
The balance is set to one extreme.
Adjust the balance properly (see page 15).
The station is too far away. Select a new station.
Antennas are not connected properly.
Check connections.
"OVERLOAD" stalts flashing on the
display.
Speakers are overloaded because of high
volume.
1. Press STANDBY/ON O/I on the front
panel to turn off the receiver.
2. Stop the playback source.
3. Turn on the receiver again, and adjust the
volume.
"DSP MICON NG" starts flashing on the
display.
The built-in microcomputer is not
functioning correctly.
Press STANDBY/ON O/I on the front panel to
turn off the receiver. After unplugging the
power cord, consult your dealer.
Remote control does not work. There is an obstruction in front of the
remote sensor on the receiver.
Remove the obstruction.
Remote control does not work as you
intend.
The remote control is not ready for your
intended operation.
Press SOUND or a source selecting button
first, then press the buttons you want to use.
(See pages 25 to 27).
3O
To Next Page
Loading...
Need help?
General
