Speaker size
Register the sizes of all the connected speakers.
° When you change your speakers, register the information about
the speakers again.
I Press SETTING repeatedly until _E.,NG
"FRNT SP (Front speaker)" "CNTR g:_
SP (Center speaker)" or "REAR SP
(Rear speaker)" (with the current setting)
appears on the display.
2 Press CONTROL UP A/DOWN • to CeNT,eL
DOWN UP
select the appropriate item about the [I I I
speaker selected in the above step.
• Each time you press the button, the display
changes as follows:
" LARGE *_- SMALL _l
, NONE
SMALL : Select this when the speaker size is relatively small.
(See "Notes" below.)
3 Repeat steps I and 2 to select the appropriate
items for other speakers.
Notes:
• Keep the following comment in mind as reference when adjusting.
- If the size of the cone speaker unit built in your speaker is greater
than 12cm (4 3/4inches), select "LARGE," and if it is smaller than
12 cm (4 3/4inches), select "SMALL."
° If you have selected "NO" for the subwoofer setting, you can only
select "LARGE" for the front speaker setting.
° If you have selected "SMALL" for the front speaker setting, you
cannot select "LARGE" for the center and rear speaker settings.
Speaker distance
Register the unit you use, then the speaker distance from your
listening point.
° If you have set the unit before, start from step 3
Press SETTING repeatedly until SE.,NG
"UNIT" (with the current setting)*
appears on the display.
* "METER" is the initial setting. If you have already changed
the setting, "FEET" will be shown.
Press CONTROL UP A/DOWN • to CON_,OL
DOWN UP
select the unit. " "
• Each time you press the button, the setting i
alternates between "METER" and "FEET."
-</
FEET : Speaker distance is shown in feet.
3 Press SETTING repeatedly until ,,_,N,
"FRNT DIS (Front distance)" "CNTR _.'x<'_
DIS (Center distance)" or "REAR DIS
(Rear distance)" (with the current setting)*
appears on the display.
The display shows the current setting in the unit selected in step 2.
* "3.0m" is the initial setting for meter and "10FT" is for feet. If
you have already changed the setting, another value will be
shown.
4 Press CONTROL UP A/DOWN • to DOwNOON_"%
select the appropriate speaker [I iI
distance.
• If you have selected "METER" in step 2, the
value is changed from "0.3m" to "9.0m" by 0.3 m step.
• If you have selected "FEET" in step 2, the value is changed
from "IFT" to "30FT" by 1 foot step.
3.0m
",, (10 feet)
2.7 rn
, ', (9 feet) '
_ 2.4 m '_
' (8 feet) ,
i , i
2.1 m
r r
(7 feet) ' ,
t
Example: In this case,
set "FRNT DIS" to "3.0m" or "10FT,"
set "CNTR DIS" to "2.7m" or "9FT" and,
set "REAR DIS" to "2.4m" or "8FT."
Note:
If you have selected "NONE" for the center and rear speakers
setting, you cannot set the speaker distance for the center and
rear speakers.
13
/
w
g=
=.
€,,g=
tOID
To Next Page
Loading...
Need help?
General
