You can use the remote control to operate other JVC's
components.
IMPORTANT:
To operate JVC's audio components using this remote control:
• You need to connect JVC's audio components through the COMPU
LINK (SYNCHRO) jacks (see page 24) in addition to the
connections using cables with RCA pin plugs (see page 6).
• Aim the remote control directly at the remote sensor on the receiver.
• If you use the buttons on the front panel, the remote control will not
operate that source. To operate a source with the remote control,
the source must be selected using source selecting buttons on the
remote control.
• To operate the cassette deck or CD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 8.)
• Refer also to the manuals supplied with your audio components.
Sound Adjustment
You can always perform the following operations:
SURROUND MODE : Select the Surround modes.
After pressing SOUND, you can use the following buttons for sound
adjustment:
CENTER +/- : Adjust the center speaker output level.
REAR*R +/- : Adjust the right rear speaker output level.
TEST : Turn on or off the test tone output.
Note:
After adjusting sounds, press the corresponding source selecting
button or CD-DlSC to operate your target source by using the 10
keys; otherwise, the 10 keys cannot be used for operating your target
source.
Tuner
You can always perform the following operations:
FM MODE :Change the FM reception mode.
After pressing FM/AM, you can use the following buttons for tuner
operations:
/
O
3=
"u
ip,.=
m
Z
¢D
o
o
=
O
Ill
C=
L
mo
o
mo
L
¢D
o
o
"o
o
After pressing CD, you can use the following buttons for CD
operations:
1<4 : Return to the beginning of the current
(or previous) track.
• : Stop playback.
1 - 10, +10 : Select a track number directly.
• For track number 5, press 5.
• For track number 15, press +10, then 5.
• For track number 20, press +10, then 10.
25
To Next Page
Loading...
Need help?
General
