Fig.14: Opening the cardboard packaging Fig.15: Setting the device upright
Legend
1 Hood 4 Base section
2 Upper side section 5 Lower side section
3 Clip lock (4x) 6 Cardboard packaging with mount and mounting kit
↻ The device is transported to the installation location.
1. Remove the plastic strap from the pallet and packaging.
2. Pull the clip lock off the packaging.
3. Pull the hood upwards to remove it and place the cardboard packaging to one side together with the mount
and accessories.
4. Set the device upright with the base section and side sections.
5. Remove the uppermost side section and base section from the device.
ð If the device is in the correct installation position: Proceed with the installation of the mount.
6.3 Fastening the mount
CAUTION
Hazard when using unsuitable fixing materials!
If unsuitable fixing materials are used, the device could fall and persons in front of the device may be
seriously injured.
1. Use only fixing materials that are suitable for the mounting base. The fastening materials supplied
are only suitable for masonry and concrete.
2. Only install the device in an upright position.
Manual Installation and preparation | 6
KACO blueplanet 87.0 TL3 KACO blueplanet 92.0 TL3 KACO blueplanet 105 TL3 KACO blueplanet 110 TL3
KACO blueplanet 125 TL3 KACO blueplanet 137 TL3 KACO blueplanet 150 TL3 KACO blueplanet 155 TL3 KACO
blueplanet 165 TL3
Page 21
EN-US
To Next Page
Loading...
Need help?
General