4 Interfaces
4.1 Operator interface
The interface fullls the following functions:
• Communication with the F6 device (protocol DIN 66019 II)
• Voltage supply of the operator
A combined RS485 interface is used as interface, which is provided as 9-pole D-Sub
plug connector.
Figure 3: D-Sub 9-pole
4.1.1 Remote control
NOTICE
Malfunctions in case of own manufacture!
► When manufacturing an extension cable yourself, the assignment
must be made without pins 1, 2 and 3.
► Connections of pins 4, 5, 6, 7, 8, 9 and the shield are sucient.
► The maximum length is 10 meters (depending on the cable cross-
section).
16
INTERFACES