KEB COMBIVERT F5 MULTI User Manual

11
13
11
KEB COMBIVERT F5
Name: Basis
04.05.04
© KEB Antriebstechnik, 2002
All rights reserved
Chapter Section PageDate
Network Hardware
Networks
11.1.1 Available Hardware
11.1 Network
Components
The KEB COMBIVERT F5 can be easily integrated into different networks. For that
purpose the inverter is fitted with an operator that is appropriate for the respective
bus system. Following hardware components are available:
– RS232-Cable PC/Operator Part No.: 00.58.025-001D
for operation with interface operator
– HSP5-Adaptor PC/Control board Part No.: 00.F5.0C0-0001
for operation without operator; RS232 => TTL
– F5 Interface-Operator Part No.: 00.F5.060-2000
serial networks in RS232 or RS485-standard
– F5 Profibus-DP-Operator Part No.: 00.F5.060-3000
– F5 InterBus-Operator Part No.: 00.F5.060-4000
– InterBus-Remote bus interface connection Part-No.: 00.B0.0BK-K001
(in connection with Interface-Operator)
– F5 CanOpen-Operator Part No.: 00.F5.060-5000
– F5 Sercos-Operator Part No.: 00.F5.060-6000
11. Networks
11.1.2 RS232-Cable PC /
Operator
00.58.025-001D
The cable of 3m length is used for the direct RS232-connection between PC (9-pole
SUB-D-connector) and operator.
The RS232-cable is suitable exclusively for the communication between PC
and Operator. If the cable is plugged in directly onto the control board, it can
lead to the desctruction of the interface of the PC.
11.1.3 HSP5-Cable PC /
Control Board
00.F5.0C0-0001
The HSP5-cable is used for the direct connection between PC and control board.
The necessary conversion to TTL-level occurs in the cable.
9-pole SUB-D coupling 9-pole SUB-D connector
PC
F5-Control board
PC
HSP5
TTL
2
3
5
2
3
7
9-pole SUB-D coupling 9-pole SUB-D connector
Housing (PE)
PC F5-Operator

KEB COMBIVERT F5 MULTI Specifications

General

Brand	KEB
Model	COMBIVERT F5 MULTI
Category	DC Drives
Language	English