Installation – Connecting the camera to your network using WPS
43
Connecting the camera to your network using WPS
An alternative method of connecting your camera to your network is by using WPS. WPS is a quick, simple and secure method of adding devices to
a network. If you have a router which supports WPS follow the steps below, otherwise, please use the wired mode of setting up the camera.
Note: Please complete the following steps within 2 minutes.
1. Press the WPS button on your wireless device to activate the function.
2. Press the WPS button of your wireless network camera for at least 5 seconds. The WPS light will start to blink green. Within 2 minutes, the
WPS light will either show a solid green light indicating that the connection was successful or the light will stop flashing and will not be
illuminated. If the light is not illuminated after 2 minutes, the connection was unsuccessful. Try repositioning the camera or router and try the
WPS connection again.
To Next Page
Loading...
Need help?
General