Keebox IPC1000W User Manual

KView Software
76
2. Select the camera to add from the list, enter the administrator’s user name (ID) and password, a preview of the live video display will appear.
Click OK, add this camera, a confirmation message informs when the camera is connected and added to the KView monitoring group.
Repeat this procedure for all the cameras being added. Click the Exit button after all the cameras have been added.
If the camera does not appear listed, click the Input the location of camera tab above the list to view a new menu. Enter the IP address or
the URL (for example, ipcam.ddns.org) of the camera being added, type the user name and password and click Preview to verify that a link
can be established. The live video of the camera should appear in the Live preview display. If a link cannot be established, run the Setup
Wizard software for the camera and verify the correct IP address. Click Exit to return to the main Add camera menu.
3. Once the cameras have been added, they are ready to be used in the main KView user interface. Close the Add camera menu (click Exit) to
go to the main user interface. See below for a description.

Keebox IPC1000W Specifications

General

Brand	Keebox
Model	IPC1000W
Category	IP Camera
Language	English