Keithley 2470 User Manual

Model 2470
High Voltage SourceMeter Instrument User's Manual Section 3:
Using a remote interface
2470-900-01 Rev. A / May 2019 3-11
9. In the Virtual Instrument Name box, enter a name that you want to use to refer to the instrument.
10. Select Finish.
11. Select Cancel to close the Wizard.
12. Save the configuration. From the Keithley Configuration Panel, select File > Save.
Verify the instrument through the Keithley Communicator:
1. Click Start > Keithley Instruments > Keithley Communicator.
2. Select File > Open Instrument to open the instrument you just named.
Figure 17: Keithley Communicator Open an Instrument
3. Click OK.
4. Send a command to the instrument and see if it responds.
If you have a full version of NI-VISA on your system, you can run NI-MAX or the VISA Interactive
Control utility. See the National Instruments documentation for information.

Keithley 2470 Specifications

General

Brand	Keithley
Model	2470
Category	Power Supply
Language	English