SECTION il. GETTING READY TO SEW
Connecting Machine to Power Supply
Power supply plug
(_ Power switch
Outlet
(_ Machine socket
('_ Machine plug
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch (_).
2. Insert the machine plug(_)into the machine socket (_.
3. Insert the power supply plug_)into the outlet(_.
4. Turn the power switch (_to turn on the power and
sewing light.
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabdc under the presser foot and run the machine
without thread for a few minutes. Wipe away any oil which
may appear.
For Your Safety.
* While in operation, always keep your eyes on the sewing
area, Do not touch any moving pads, such as the thread
take-up lever, handwheel or needle,
* Always turn off the power switch and unplug from the
power supply:
- Wllen leaving the machine unattended
- When attaching or removing any parts
- When cleaning the machine
* 13onot place anything on the foot control, when not
sewing.
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of an electric shock, this plug
is intended to fit in a polarized outlet only one way. If the
plug does not fit in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
Foot Controller Model YC-482J or TJC-150 is used with
Sewing Machine Model 385.11206XXX (XXX represents
numbers 000 through 999).
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
f
J
6
To Next Page
Loading...
Need help?
General
