Setting Spool Pin
(_ spoolpin
The spool pin holds the spool of thread for feeding the
thread to the machine.
Pull out the spool pin and place the felt on it.
Presser Foot Lifter
(_ Presser foot lifter
(_) Normal up position
(_) Highest position
The presser foot lifter raises and lowers the presser foot.
You can raise it about 1/4" (0.6 cm) higher than the normal
up position for easy removal of the presser foot, or to help
you place heavy fabric under the foot.
Extension Table
- Detaching the table
Pull the table away from the machine, as illustrated, for
"free-arm" sewing of cuffs and sleeves.
° Attaching the table
Push the extension table until it snaps into the machine.
(_ Extension table (_)Tab
(_ Hole -[_Free-arm
Changing Needle
Q Needle clamp screw
(_ Needle clamp
[]]Turn off the power switch.
Raise the needle to its highest position by turning the
handwheel counterclockwise, toward you, and !owedng
the presser foot. Loosen the needle clamp screw(_by
turning it counterclockwise. Remove the needle from the
needle clamp (_.
[] Insert a new needle into the needle clamp(_)with the
flat side to the rear. When inserting the needle into the
needle clamp (_, push it up as far as it goes. Tighten
the needle clamp screw _ firmly by turning it clockwise.
I_To see if the needle is good, place the flat side of the
needle onto something flat (e.g needle plate or glass).
The gap between the needle and the flat surface should
be consistent. Never use a bent or blunt needle.
A damaged needle can cause permanent snags or runs
in knits, fine silks and silk-like fabrics.
f
l Flat side
Lado piano _ Needle
Meplat vers Aguja
Aigullle
I
!
J
8
To Next Page
Loading...
