SEWING MACHINE DIV.20 MODEL 385. 17822490
THREADING OF MACHINE
THE NUMBERED STEPSBELOW FOLLOW THE NUMBERS ON THE ILLUSTRATIONS.
DOTrED LINES SHOW PLACES WHERE LOOPS AND THEN ISPULLED TIGHT.
RAISE THE TAKE-UP LEVER TO ITS HIGHEST POSITION BY TURNING THE HAND WHEEL
TOWARD YOU.
RAISETHE PRESSERFOOT LEVER.
PLACE SPOOL ON PIN WITH THREAD COMING FROM THE BACK OF THESPOOL.
1. DRAW THREAD THROUGH THETHREAD GUIDE.
2. HOLDING THREAD TAUT WITH RIGHT HAND, DRAW THREAD DOWN INTO THE TENSION
AREA AND THEN AROUND THECHECK SPRING HOLDER.
3. FIRMLY DRAW THREAD UP AND THROUGH THE TAKE-UP LEVER FROM RIGHTTO LEFT.
4. PULLTHETHREAD TO THE LEFTAND SLIP ITINTO THE NEEDLE BAR THREAD GUIDE.
5. HTREAD NEEDLE FROM FRONT TO BACK.
NOTE: YOU MAY WANT TO CUT THE END OF THREAD WITH SHARP SCISSORS FOR
EASIERNEEDLE THREADING.
J
5
To Next Page
Loading...
Need help?
General
