3-3
6. (OPTIONAL STEP) If desired, press CYCLE
SIGNAL. A signal will sound to alert you
when a cycle ends. For more details, see
“Cycle Signal.”
7. Press START. Be sure the door is closed.
If you do not press Start within 5 min-
utes of selecting the cycle, the dryer
automatically shuts off.
If you wish to end your drying cycle after
pressing Start, press STOP twice.
STOPPING, PAUSING OR
RESTARTING
To stop or pause your dryer at any time
Open the door or press STOP once. Press
STOP twice to cancel a cycle.
To restart the dryer
Close the door. Press START until dryer
starts.
NOTE: Drying will continue from where the
cycle was interrupted if you close the door
and press Start within 5 minutes. If the cycle is
interrupted for more than 5 minutes, the dryer
will shut off. Select new cycle settings before
restarting the dryer.
DRYING AND CYCLE TIPS
Select the correct cycle and dryness level or
temperature for your load. If an Auto Dry Cycle is
running, the display shows the estimated cycle
time when your dryer is automatically sensing
the dryness level of your load. If a Timed Cycle
is running, the display shows the exact number
of minutes remaining in the cycle.
Cool Down tumbles the load without heat during
the last few minutes of all cycles. Cool Down
makes the loads easier to handle and reduces
wrinkling. The length of the Cool Down depends
on the load size and dryness level.
•
•
DRYING TIPS
Follow care label directions when they are
available.
If desired, add a fabric softener sheet. Fol-
low package instructions.
To reduce wrinkling, remove the load from
the dryer as soon as tumbling stops. This is
especially important for permanent press,
knits and synthetic fabrics.
Avoid drying heavy work clothes together
with lighter fabrics. This could cause over
-
drying of lighter fabrics and lead to increased
shrinkage or wrinkling.
CYCLE TIPS
Dry most loads using the preset cycle set-
tings.
Refer to the Auto or Timed Preset Cycle
Settings charts (in the “Cycles” section) for
a guide to drying various loads.
Drying temperature and dryness level
are preset when you choose an Auto
Dry Cycle. You can select a different
dryness level, depending on your load,
by pressing Dryness Level and choos
-
ing More, Normal or Less.
NOTE: You cannot use the Time Adjust
and you cannot choose a Temperature
with the Auto Dry Cycles.
If you wish to adjust the cycle length of
a Timed Cycle, press the Time Adjust
(More Time or Less Time) arrows. Ad-
just the temperature of a Timed Cycle by
pressing Temperature until the desired
temperature is selected.
NOTE: You cannot choose a dryness
level with Timed Cycles.
•
•
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General