Kenwood C-V351 User Manual

36
C-V351/C-V301 (EN)
1
Select the Dolby Pro Logic surround mode.
ENTER
PRO LOGIC
ENTER
ENTER
Tone/
Balance
Sound
Set Up
ENTER
ENTER
L
||||||||||
+
||||||||||
R
7
ENTER
ReturnReturn
ENTER
Sound
STEREO
PRO LOGIC
3 STEREO
Each press switches the adjusted items as shown below.
1 BASS :Tone, Bass
2 TREBLE :Tone, Treble
3 L- - - - - - -R :Balance
4 C ch :Center speaker
5 SR ch :Surround speaker, Right
6 SL ch :Surround speaker, Left
7 SW ch :Subwoofer
8 DELAY :Delay time
9 INPUT :Input level
Setup Sound
Tone/
Balance
Speaker Level
Input Level
Test Tone DSP
Delay Time
-6dB
2
The feeling of presence in the surround effects can be
improved by performing the following adjustment proce-
dure according to the speaker system and listening room
environment in use.
Once they are adjusted, re-adjustment is not necessary even
after the surround mode is switched to other modes.
Adjustment sequence
Balance
adjustment
Adjustment
with test tone
Delay time
adjustment
Setup for surround play
÷ Select the surround mode according to the played source and compo-
nent in use.
÷ Switching is not possible when the 6ch INPUT is used.
Select an icon.
÷ Adjustment items 5, 6 and 8 are not required in the 3 STEREO mode.
÷ The adjusted items which can be selected with 6ch INPUT are 3, 4, 5,
6 and 7, in this sequence.
÷ Those which can be selected when SOURCE DIRECT is ON are 7 and 9.
Adjust the balance. “L- - - - - - -R”
1 Select the Balance adjustment display.
2 Adjust the levels of the front speakers (Left, Right) so that
they sound identical.
To decrease right
channel level
To decrease left
channel level
3 Quit the balance adjustment.
If no key on the main unit has been pressed for about 5 seconds, the
display on the main unit disappears and it returns to the status before
the setup mode was entered.
The display on the GRC disappears if no key on the GRC has been
pressed for about 10 seconds.
Ambience effects
Indicates the balance setting
Position of the right speaker
Indicates the center
Position of the
left speaker
Main operation menu
GRC
RC/Main unit
To decrease right
channel level
To decrease left
channel level
L
-
--
y
t
--R
RC
GRC
RC
GRC
PRO LOGIC
MODE
LEVEL
MULTI
CONTROL

Kenwood C-V351 Specifications

Audio

total harmonic distortion	0.01 %
signal to noise ratio CD	93 dB
input sensitivity / impedance CD	200 mV / 47kΩ

FM Tuner

tuning frequency range	87.5 MHz~108 MHz
usable sensitivity MONO	1.2 µV (at 75 Ω) / 13.2 dBf
signal to noise ratio MONO	65 dB (65.2 dBf input)

Weight and Dimensions

dimensions	W:400 mm H:105 mm D:382 mm
weight	5.2 kg
power consumption	25 W