Kenwood C-V351 User Manual

46
C-V351/C-V301 (EN)
1
4
TIMER
MODE
TIMER
SET
Timer operation
Two 24-hour timer systems (TIMER 1, TIMER 2) (which can
be used every day) and a sleep timer system (which works
only once) are available.
In each of TIMER 1 and TIMER 2, the timer data including the
operating period and played contents can be set and se-
lected to be activated or not as required.
Timer reservation is possible for the two types TIMER
1 and TIMER 2 at the same time.
÷Please make reservations with an interval of at least one
minute, so that the operation times of TIMER 1 and TIMER 2
do not overlap.
Timer playback, timer recording (TIMER 1, TIMER 2)
With each of the two timer programs, a selected source can be
played (or radio broadcast can be recorded) in the previously set time
period.
Sleep timer
The unit is put to STANDBY mode automatically after the specified
period has elapsed.
o
Timer programming
Make preparations for the play (recording).
÷ To listen to radio ÷ To listen to CD/LD/MD
/DVD
÷ To listen to tape ÷ For broadcast
recordings
The station should be
preset before timer pro-
gramming.[[•ª
Insert a disc.
(Program playback is not pos-
sible.)
Insert a tape. Make prepara-
tions for record-
ing. ’∞
If tapes are inserted in both
decks A and B, playback starts
with the tape in deck B.
Select a TIMER No.
2 Press immediately after selection.
Each press of the key switches the TIMER numbers as follows.
1 TIMER 1
2 TIMER 2
3 TIMER 1,2
4 OFF
÷ The selected TIMER No. lights.
÷ If a previously programmed TIMER No. is selected, the contents will be
replaced by the new contents programmed.
÷ The timer programming operation is not possible when TIMER 1,2
have already been selected.
Main unit
TIMER
1

VOLUME CONTROL
DOWN
UP
ON/STANDBY
Set the (ON/STANDBY) switch to STANDBY.
Adjust the listening volume.
Main unit
Main unit
÷ The VOLUME CONTROL should be set to the desired volume while
the unit is ON.
3
2
1 Select the timer number.

Kenwood C-V351 Specifications

Audio

total harmonic distortion	0.01 %
signal to noise ratio CD	93 dB
input sensitivity / impedance CD	200 mV / 47kΩ

FM Tuner

tuning frequency range	87.5 MHz~108 MHz
usable sensitivity MONO	1.2 µV (at 75 Ω) / 13.2 dBf
signal to noise ratio MONO	65 dB (65.2 dBf input)

Weight and Dimensions

dimensions	W:400 mm H:105 mm D:382 mm
weight	5.2 kg
power consumption	25 W