2 BASIC OPERATION
10 Index Contents Confidential FUNC (K)/Ver. 1.01
2.6 Channel Entry
Channel Entry can be used to directly change the
CH/GID.
A CH/GID number in the current zone can be selected by
entering numbers after pressing the Channel Entry key.
The transceiver automatically detects the highest channel
number. Enter the number to specify the channel.
Transceiver Operation
z If the maximum channel number has 3 numeric
digits:
1. Press the Channel Entry key.
The transceiver enters Channel Entry Mode.
2. Enter the channel number.
• Press the [1], [2] and [8] keys to recall the
channel number 128.
• Press the [0], [9], and [0] keys to recall the
channel 90.
• Press the [0], [0] and [7] keys to make a
call to recall the channel number 7.
z If the maximum channel number has 2 numeric
digits:
1. Press the Channel Entry key.
The transceiver enters Channel Entry Mode.
2. Enter the channel number.
• Press the [9] and [0] keys to recall the
channel number 90.
• Press the [0] and [7] keys to recall the
channel number 7.
z If the maximum channel number has only 1
numeric digit:
1. Press the Channel Entry key.
The transceiver enters Channel Entry Mode.
2. Enter the Channel number.
• Press the [7] key to recall the channel
number 7.
Note:
If no key is pressed before the Mode Reset Timer expires
while in Channel Entry Mode, the previous display appears
on the display.
If an unprogrammed channel is specified, the transceiver
returns to the channel used before the transceiver entered
Channel Entry Mode.
The transceiver pauses scanning when the transceiver
enters Channel Entry Mode during the scan and resumes
scanning when the transceiver exits from Channel Entry
Mode.
Following key operations are available while entering the
channel number in Channel Entry Mode.
Table 2-1 Key Operation
Configuration using KPG-101D
• Assigning functions to the PF keys (Refer to
FPRG 6.8 Key Assignment.)
2.7 Home CH/GID
This function is used to jump to a frequently used
CH/GID with a single press of a key. The transceiver can
jump to a CH/GID in the same zone instantly.
Home CH/GID can be changed using the PF key if
Operator Selectable Home-CH/GID is configured by
using KPG-101D.
Home CH/GID can be configured by using KPG-101D.
Note: Refer to Scan Function for operation if the Home CH/GID
key is pressed during the scan. (Refer to 21.1.4 Operation
after Manually Changing the Zone-CH/GID during the Scan
on page 106.)
Transceiver Operation
z Jumping to the Home CH/GID
1. Press the Home CH/GID key.
The transceiver jumps to the Home CH/GID
configured for the current zone.
Key Operation
Selector
Increments or decrements the
CH/GID
*1
*1
If “4-key” is selected from the Product Information window >
Key dropdown list:
Side 1
The transceiver exits from the
current mode.
[S]
The transceiver exits from the
current mode.
*1
Confirms the channel number
*2
*2
When “16-key” is selected from the Product Information window
> Key dropdown list:
[A]
The transceiver exits from the
current mode. *1
Deletes a character.
[<B] -
[C>] -
Side 2 -
[0] to [9] Enters the channel number.
[*] Confirms the CH/GID.
[#] Deletes a character.
PTT switch
The transceiver exits from the
current mode and transmits.
To Next Page
Need help?
General
