To Next Page

To Previous Page

4 SOUNDS

FUNC (K)/Ver. 1.01 Confidential Contents Index 21

4.1.5 Sidetone

The transceiver emits this tone if a communication is

established or the transceiver finishes transmitting.

Table 4-6 Sidetone List

4.1.6 Alert Tone

The transceiver emits this tone when the transceiver

receives a call with DTMF, 2-tone or FleetSync.

Select 1 of 8 tones by using KPG-101D.

Table 4-7 Alert Tone List

4.2 Minimum Volume

This function can be used to limit the minimum volume

level if the Volume control is turned to its lowest level.

With this function, a user can hear communication even if

the Volume control is unintentionally turned to its lowest

level. The volume does not change from the level heard

while the control is set to the most counterclockwise

position. The transceiver mutes completely if the Volume

control is turned to the most counterclockwise position

while Minimum Volume is not configured.

 Configuration using KPG-101D

• Configuring the Minimum Volume (Refer to FPRG

6.7.1 Common Page 1 Tab - Minimum Volume.)

4.3 Tone Volume

This function can be used to configure the volume level of

various tones by using KPG-101D.

This function can be used to adjust the tone volume level

as appropriate for the operating environment.

Tone Volume can be configured for each tone by using

KPG-101D. The following Tone Volumes can be

configured.

Table 4-8 Available Tone Volume Settings

 Configuration using KPG-101D

• Configuring the Power-on Tone (Refer to FPRG

6.7.1 Common Page 1 Tab - Power-on Tone.)

• Configuring the Control Tone (Refer to FPRG

6.7.1 Common Page 1 Tab - Control Tone.)

• Configuring the Warning Tone (Refer to FPRG

6.7.1 Common Page 1 Tab - Warning Tone.)

• Configuring the Alert Tone (Refer to FPRG 6.7.1

Common Page 1 Tab - Alert Tone.)

• Configuring the Sidetone (Refer to FPRG 6.7.1

Common Page 1 Tab - Sidetone.)

• Configuring the Locator Tone (Refer to FPRG

6.7.1 Common Page 1 Tab - Locator Tone.)

Function Description

PTT Proceed Tone

This tone prevents the transceiver

on the receiving side from missing

calls in Conventional Group.

This tone can be used in conjunction

with the Proceed Tone Delay Time.

The transceiver emits this tone if the

transceiver establishes a connection

to the repeater by pressing the PTT

switch in Trunking System.

VOX Proceed Tone