4 SOUNDS
FUNC (K)/Ver. 1.01 Confidential Contents Index 23
4.6 PTT Proceed Tone
The transceiver emits this tone if communication is
possible after the PTT switch is pressed. The transceiver
can be configured to emit the PTT Proceed Tone.
In Trunking System, a user must start talking after the
repeater is allocated when the PTT switch is pressed.
However, this duration is not always same, so that it is
difficult for the user to know when to start talking after
pressing the PTT switch. With this tone enabled, the user
can smoothly start talking after the Proceed Tone sounds.
The PTT Proceed Tone can be also used while the
transceiver is executing a Conventional Group scan.
The transceiver can be configured to emit the Proceed
Tone by using KPG-101D.
Note:
The audio is not emitted until the transceiver emits the Proceed
Tone sound even if a user starts talking after pressing the PTT
switch.
If the PTT ID is configured for the channel while sending the
DTMF, 2-tone or Fleetsync code, the PTT Proceed Tone
configuration is reset. In this case, the configuration for PTT ID
Sidetone (FleetSync), Sidetone (DTMF) or Sidetone (2-tone) is
enabled.
Configuration using KPG-101D
• Configuring the PTT Proceed Tone (Conventional
Group) (Refer to FPRG 6.7.3 Conventional Tab -
PTT Proceed Tone.)
• Configuring the PTT Proceed Tone (Trunking
System) (Refer to FPRG 6.7.4 Trunking Tab - PTT
Proceed Tone.)
4.7 Proceed Tone Delay Time
This function can be used to control the caller’s speaker
to emit the PTT Proceed Tone after the configured
Proceed Tone Delay Time elapses.
This function prevents the transceiver on the receiving
side from missing the first part of calls.
The Proceed Tone Delay Time can be configured by
using KPG-101D. The Proceed Tone Delay Time for the
caller can be configured in conjunction with the Decode
time of the receiving party.
Note: The Proceed Tone Delay Time cannot be configured if the
PTT Proceed Tone is disabled.
Configuration using KPG-101D
• Configuring the Proceed Tone Delay Time
(Conventional Group) (Refer to FPRG 6.7.3
Conventional Tab - Proceed Tone Delay Time.)
• Configuring the Proceed Tone Delay Time
(Trunking System) (Refer to FPRG 6.7.4 Trunking
Tab - Proceed Tone Delay Time.)
To Next Page
Loading...
Need help?
General
