Before applying the power
/I’m Caution : Read this page carefully to ensure safe
operation.
Units are designed for operation as follows.
U.S.A. and Canada.. .........................................
AC 120 V only
Australia
...........................................................
AC 240 V only
Europe and U.K.
...............................................
AC 230 V only
China and Russia
.............................................
AC 220 V only
Other countries ..........
AC 1 IO-120 I 220-240 V switchable”
For the United Kingdom
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement, use only a 13-
Amp ASTA-approved (BSI 3621 fuse.
2. The fuse cover must be refttted when replacing the fuse II- the
moulded plug.
3 Do not cut off the mains plug from thus equrpment. If the plug fitted
IS not suitable for the power pornts rn your home or the cable IS too
short to reach a power point, then obtatn an appropriate safety
approved extensron lead or adapter, or consult your dealer.
If nonetheless the marns plug IS cut off, remove the fuse and
dispose of the plug immedrately, to avoid a possible shock hazard
by Inadvertent connectron to the marns supply
IMPORTANT. The wares rn the mains lead are coloured rn accordance
wrth the followrng code,
Blue
: Neutral
Brown
Love
Do not connect those leads to the earth terminal of a three-pin plug
Safety precautions
WARNING :
TO PREVENT FIRE OR ELECTRIC SHOCK,
DO NOT EXPOSE THIS APPLIANCE TO
RAIN OR MOISTURE.
CAUTION. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS
INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL,
WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF UNINSULATED
“DANGEROUS VOLTAGE” WITHIN THE PRODUCT’S EN-
CLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO
CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS
AA
THEEXCLAMATION POINTWITHINAN EQUILATERALTRI-
ANGLE IS INTENDED TO ALERT THE USER TO THE PRES-
ENCE OF IMPORTANT OPERATING AND MAINTENANCE
(SERVICING) INSTRUCTIONS IN THE LITERATUREACCOM-
PANYING THE APPLIANCE.
*AC voltage selection
The AC voltage selector switch on the rear panel is set to the voltage
that prevarls rn the area to whrch the unit IS shipped
Before
connecting the power cord to your AC outlet, make sure that the
settrng positron of this swatch matches your line voltage
If not, rt
must be set toyourvoltage II- accordancewith the followrng drrectron
AC voltage selector switch
Note:
Our warranty does not cover damage caused by excessive lrne
voltage due to rmproper settrng of the AC voltage selector swatch
2
EN
To Next Page
Loading...
Need help?
General
