CKE-BA-e-2132 13
4.4 Testing equipment supervision
Within the quality assurance system, you must check the technical measurement
properties of the scales and possibly of the available reference weight regularly. To
that aim, the responsible user should define a relevant cycle, as well as the type and
scope of such an inspection. The information on the supervision of the testing
equipment, which are scales and the required reference weights, can be found on the
home page of KERN (www.kern-sohn.com). The reference weights and scales can
be calibrated fast and for a low cost in the KERN calibration laboratory (against the
national reference) approved by DKD (Deutsche Kalibrierdienst).
5 Basic safety instructions
5.1 Compliance with the instructions included in the user manual
Before you set and start the device, read this user manual thoroughly
even if you are familiar with KERN scales.
5.2 Personnel training
The device can be operated and maintained solely by trained workers.
6 Transport and storage
6.1 Checking during reception
Immediately after you have received the shipment, please check if it is free from any
visible outer damage. The same applies for the unpacked device.
6.2 Packaging / return transport
Please keep all the parts of the original packaging in case you had
to send it back to us.
Always use the original packaging for the return transport.
Before you dispatch the device, disconnect any connected cables
as well as loose/moving parts.
Reinstall any transport locks, if present.
Protect all the parts, e.g. wind breaker, scales plates, power sup-
ply etc. from slipping and damage.
To Next Page
Loading...
Need help?
General
