AFTERTREATMENT DEVICES REGENERATION DISABLE PILOT LAMP
The aftertreatment devices regeneration disable pilot lamp
lights up when the exhaust gas aftertreatment devices are set
not to be regenerated.
REMARK
Even if the aftertreatment devices regeneration is disabled,
when the manual stationary regeneration is necessary, KDPF
soot accumulation caution lamp lights up. If KDPF soot accu-
mulation caution lamp lights up, cancel the regeneration disa-
ble setting and perform manual stationary regeneration.
For the procedures of cancellation of the regeneration disable
setting, and setting of manual stationary regeneration, see
“HANDLE KOMATSU DIESEL PARTICULATE FILTER
(KDPF)”.
LOCK LEVER PILOT LAMP
The lock lever pilot lamp lights up when the lock lever is in LOCK position.
It goes out when the lock lever is set in FREE position.
ECO GUIDANCE
The guidance for energy saving operation to reduce the fuel
consumption may be displayed during operation.
The details of the guidance are as follows:
Idling Stop Guidance
If no operation is performed for more than 5 minutes, and the
engine is idling, the idling stop message is displayed on the
monitor. When waiting for work or taking short break, stop the
engine to reduce unnecessary fuel consumption.
The idling stop message goes out if any lever is operated again
or switch F5 is pressed.
EXPLANATION OF COMPONENTS OPERATION
3-36
To Next Page
Loading...
Need help?
General
