METHOD FOR OPERATING ATTACHMENT
WARNING
If the travel levers or travel pedals are operated when the engine speed is decreased by the auto-decel-
eration function, the engine speed will suddenly increase. Be careful.
If you perform operations with your foot on the pedal, the attachment may suddenly move if you de-
press the pedal by mistake, and this may lead to serious personal injury or death. Do not rest your foot
on the pedal except when you operate the pedal.
When the attachment is not used, set the lock pin of the pedal to LOCK position to prevent the pedal
from being operated.
When you are going to grab something with the attachment, do not release the pedals and proportional
switches while holding the object.
When you operate attachment, the screen will switch to the screen including bird's eye view automati-
cally.
For the change of the flow setting for the breaker mode and attachment mode for the crusher, etc., see “MA-
CHINE SETTINGS”.
METHOD FOR OPERATING MACHINE WHEN WORKING MODE IS NOT IN
BREAKER MODE
Change the working mode and enter the Breaker Mode.
1.
Press working mode selector switch (1).
The screen changes to the working mode selection
screen.
2.
Press working mode selector switch (1) or press switches
F3 or F4 to select Breaker Mode B.
3.
With Breaker Mode B highlighted in yellow, do one of the
followings to enter the selection.
1)
To keep working mode selector switch (1) pressed.
2)
To press switch F6.
3)
To leave as it is for 5 seconds.
HANDLE MACHINE READY FOR INSTALLATION OF ATTACHMENT ATTACHMENTS AND OPTIONS
6-48
To Next Page
Loading...
Need help?
General
