Refer to “BREAKER MODE SWITCH” for warnings and explanation of operation.
ADDITIONAL LAMPS SWITCH
(if equipped)
The additional lamps switch is used to turn on the cab front
lamps, cab rear lamps and extra boom lamps (If fitted by cus-
tomer)
(a) ON
Lamps light up.
(b) OFF
Lamps go out.
CONTROL LEVERS AND PEDALS
(1) Lock lever
(2) Travel levers (with pedal and auto-deceleration
system)
(3) L.H. work equipment control lever (with auto-decel-
eration system)
(4) R.H. work equipment control lever (with auto-de-
celeration system)
LOCK LEVER
WARNING
• When leaving the operator's seat, set the lock lever securely to LOCK position. If the lock lever is
not at LOCK position and the control levers or control pedals are touched by mistake, it may lead to
serious personal injury or death.
• Always check that the lock lever is in LOCK position.
• When pulling the lock lever up, or when pushing the lock lever down, be careful not to touch the
work equipment control lever.
• Before setting the lock lever to FREE position, make sure that all control levers and pedals are set
to NEUTRAL position. If any of them is out of NEUTRAL position, the work equipment or machine
may move suddenly and cause a serious personal injury or death.
EXPLANATION OF COMPONENTS OPERATION
3-96
To Next Page
Loading...
Need help?
General
