Applicable operations
7 Quarry work or digging bedrock N
8 Lifting N
* Work allowed only with specialist cutting basket.
METHOD OF WORK
• Avoid operating the bucket cylinder and arm cylinder to the end of their stroke.
• Use the maximum specific gravity 1.8 t/m
3
• Take care when using the super long front machine on soft ground. Ensure the ground has sufficient
strength to support the weight of the machine with loaded bucket before commencing operations.
• Where possible, avoid using the super long front machine on slopes.
• Do not use this equipment for compacting slope faces.
• When travelling, lower the boom, pull in the arm, keep the work equipment parallel to the track and travel
slowly.
• Do not use any bucket with a capacity greater than shown in this table.
Buckets which do not conform to this table must not be used.
Item
Unit PC210LC-11 15m
Max digging radius  mm 1200
General Purpose Bucket, material density 1.8 t/m
3
• Capacity (ISO)
 m
3
0.49
• Maximum Width
 mm 955
• Maximum Weight
 kg 425
General Purpose Bucket, material density 1.2 t/m
3
• Capacity (ISO)
 m
3
0.66
• Maximum Width
 mm 955
• Maximum Weight
 kg 525
Powered attachment
• Maximum Weight at the end of the arm
 kg 800
Bucket
• Maximum Weight at the end of the arm
 kg 1300
Ditching Bucket, material density 1.5 t/m
3
• Maximum Width
 mm 2100
Values shown are in accordance with EN474-5:2006+A1:2009 (E)
WARNING
Do not use any attachment which imposes vibration loading onto the equipment.
CAUTION
The Super Long Front machine is not to be used for lifting.
SUPER LONG FRONT BOOM AND ARM ATTACHMENTS AND OPTIONS
6-26
To Next Page
Loading...
Need help?
General
