Kramer VM-218DTxr User Manual

Kramer Electronics Ltd.
VM-218DTxr, VM-218DT – Connecting the HDMI/HDBT Switcher DA
14
Cascading Devices
Use the OUT 1 HDMI connecter on VM-218DTxr to connect a local monitor or to
distribute the signal to an additional receiver, thus creating a 2x16 DA system as described in
the following example.
To cascade VM-218DTxr:
1. Connect the inputs and outputs to the primary device as described in Connecting the
HDMI/HDBT Switcher DA on page 8, except for the OUT 1 HDMI connector.
2. On the cascaded DA device, connect the receivers as required.
Connect the power to the receivers only after connecting them to the cascaded device.
3. Connect the OUT 1 HDMI connector on the primary device to the IN 1 HDMI connector
on the cascaded DA device.
4. After powering the cascaded device, make sure that the HDMI input is selected on the
cascaded device.
Figure 5: Cascading DAs
18
14

Kramer VM-218DTxr Specifications

General

Brand	Kramer
Model	VM-218DTxr
Category	Switch
Language	English