Kramer VM-218DTxr User Manual

Kramer Electronics Ltd.
VM-218DTxr, VM-218DT – Defining VM-218DTxr HDMI/HDBT Switcher DA
5
Defining VM-218DTxr HDMI/HDBT
Switcher DA
VM-218DTxr and VM-218DT appear identical.
This section defines VM-218DTxr.
Figure 1: VM-218DTxr HDMI/HDBT Switcher DA Front Panel
#
Feature
Function
IR LED
Lights orange when the unit accepts IR remote commands.
IR Sensor
Use to control a peripheral device connected to OUT 2 HDBT with that
device’s remote controller.
POWER LED
Lights when the unit is powered.
VOLUME ()
Press to decrease the volume of the analog audio output.
VOLUME ()
Press to increase the volume of the analog audio output.
INPUT Selector Button
Press to select input 1 HDMI or input 2 HDBT.
INPUT LEDs
Lights green to indicate the selected input: 1 HDMI or 2 HDBT.
EDID READ Button
Press to read the selected EDID and write it to both inputs.
EDID SELECT Button
Press to cycle through the sources from which to read the EDID: Default,
External, or Output. When Output is selected, cycles through outputs 1 to 9.
The relevant EDID TYPE and OUTPUT LEDs light green.
EDID TYPE LEDs
Lights green to indicate the selected EDID type: DEFAULT, EXT. (external)
or OUTPUT.
OUTPUT LEDs (1 to 9)
In normal operation mode: lights green when an acceptor is connected to the
output.
In EDID mode: when EDID TYPE OUTPUT LED lights green, press the
EDID SELECT button briefly to cycle through output 1 to 9 to select the
output from which to read EDID. The relevant LED lights during EDID setup
and remains lit after completing the EDID setup.

Kramer VM-218DTxr Specifications

General

Brand	Kramer
Model	VM-218DTxr
Category	Switch
Language	English